Damasteel® Dense Twist™ - 38x4mm
Info about an order :
If you enter order quantity "1", you get 1cm length of the steel
With order quantity "20" you get 20 cm length of the steel
Minimum order quantity 10cm
Under remark you can give details - for example if you want to separate the steel into several pieces !
Production method: powder metallurgical, pattern embossed and plan milled
Uses: Knife blades, cutlery knives, cutting tools, jewelry
Properties in use: Hardness range up to 60 HRC for knife blades, stainless, good cut resistance, easy care
Properties in delivery condition: soft annealed, hardness max. 300 HV
Processing instructions: easy to machine, easy to work by hand, easy to etch,
very good polishing, conditionally forging,
Hardness instructions see data sheet in the annex
Properties in use: good sharpening, good cut retention, easy care, good polishing
Tips: the heat treatment should be carried out with deep-frozen treatment
in order to exploit the full power range of the steel
sharpenable with water/oil stones, ceramic and diamond sharpeners
Cutting angle up to minimum 30° (depending on the remaining blade geometry and
Use / handling, see instructions above)
Care: rinse (with/without detergent) and dry is sufficient,
Oil film not required
easy polishing to accentuate the damask pattern (depending on the etching depth) is possible
